Home > Knowledge > Content

Operation of Electrogas welding

Dec 15, 2016

In EGW, the heat of the welding arc causes the electrode and workpieces to melt and flow into the cavity between the parts being welded. This molten metal solidifies from the bottom up, joining the parts being welded together. The weld area is protected from atmospheric contamination by a separate shielding gas, or by the gas produced by the disintegration of a flux-cored electrode wire. The electrode is guided into the weld area by either a consumable electrode guide tube, like the one used in electroslag welding, or a moving head. When the consumable guide tube is used, the weld pool is composed of molten metal coming from the parts being welded, the electrode, and the guide tube. The moving head variation uses an assembly of an electrode guide tube which travels upwards as the weld is laid, keeping it from melting.

Electrogas welding can be applied to most steels, including low and medium carbon steels, low alloy high strength steels, and some stainless steels. Quenched and tempered steels may also be welded by the process, provided that the proper amount of heat is applied. Welds must be vertical, varying to either side by a maximum of 15 degrees. In general, the workpiece must be at least 10 mm (0.4 in) thick, while the maximum thickness for one electrode is approximately 20 mm (0.8 in). Additional electrodes make it possible to weld thicker workpieces. The height of the weld is limited only by the mechanism used to lift the welding head—in general, it ranges from 100 mm (4 in) to 20 m (50 ft).

Like other arc welding processes, EGW requires that the operator wear a welding helmet and proper attire to prevent exposure to molten metal and the bright welding arc. Compared to other processes, a large amount of molten metal is present during welding, and this poses an additional safety and fire hazard. Since the process is often performed at great heights, the work and equipment must be properly secured, and the operator should wear a safety harness to prevent injury in the event of a fall.